Sensormatic Intellex Instrukcje Operacyjne Pobierz pdf (Strona 82)

Installation and Operating Instructions

66 Setup Options

1. From the main screen, click the Setup button. The Setup Options screen appears.

2. Click the Cameras button and click the Camera Control tab.

3. For each of the cameras that will be controlled, select one of the camera handlers

from the pull-down menu:

NOTE: The Version 2.x firmware permits simultaneous local (at the Touch Tracker)

and remote (via Network Client) control of different cameras through the same

Touch Tracker. The Touch Tracker must have version 2.x firmware for this

mode to work.

4. After you select a camera handler, the Setup button will be active for that camera.

Click Setup to go to the Camera Control Setup screen , where you specify the

camera address and COM port. You MUST perform Setup on each camera with a

camera handler selected for proper operation of the Intellex unit.

• The default camera address is the Intellex camera number. Normally this is

correct. If the ADTT16E V2.x camera handler is used, the SensorNet address of

the camera must be used.

• The MUX port is the COM2 port that is normally used when the Touch Tracker

is used to select cameras on Intellex. This MUX port must be used if Touch

Tracker control is desired. Any other COM port on the Intellex can be used

only for camera control.

NOTE: The monitor number selection will switch the camera to the selected monitor

output on the switch. If local switching of the video is not desired, select an

unused monitor output on the Intellex.

NOTE: The RS-232 port on the matrix switcher MUST be set to Terminal Mode when

connecting an Intellex to an AD matrix switcher for camera control. The baud

rate on the matrix switcher should be set to 4800.

None Select if this camera cannot be controlled or you do

not wish to permit remote control of this camera.

This is the default setting.

AD168, MP48 Select if you have an AD168 or MP48 Matrix

Switcher, or if your switcher uses make/break or

start/stop polling.

AD1024 Matrix Select if you have an AD1024 switcher or if your

switcher uses continuous polling.

RS422 Dome Select if you have an RS422-connected dome.

VM16/ADTT16 Select if you have a VM16 or ADTT16E Touch

Tracker or Enhanced Touch Tracker.

VM16E/ADTT16E V2.x Select if you have a VM16 or ADTT16E with version

2.x firmware.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 237 238

Brak uwag

Sensormatic Intellex Instrukcje Operacyjne Strona 82