Sensormatic Intellex Instrukcje Operacyjne Pobierz pdf (Strona 210)

Installation and Operating Instructions

194 Installation and Use of Accessories

COM Port Assignments

These are the COM port assignments that are expected by Intellex.

Since the internal and external modems have specific port number requirements,

always install the modems before installing the port expanders. Adding the modem

later will result in reassignment of the serial port numbers. Follow this procedure:

• Install all modems. Power up the Intellex unit and allow Windows to assign COM

port numbers.

• Install the port expander(s). Allow Windows to assign serial port numbers.

• Shut down the Intellex unit and restart. The port numbers should be stable after

this.

Connecting Text Sources

Data from a text source will be recorded by Intellex if the following conditions are

met:

• The Intellex application must be able to open the COM port.

• Serial data must be present for the text stream to be listed in the playback text box.

To set up text recording on the Intellex unit follow these steps:

1. Install all desired serial devices as described above. Be sure to reboot the unit to

minimize the possibility that serial ports may be reassigned the next time the

Intellex unit starts.

2. In the Intellex application, click Setup, then Text. Click Add to set up a text stream

for recording.

COM 1 Not used (disabled in the BIOS)

COM 2 Touch Tracker interface for “MUX” control of Intellex

and dome control from Network Client. On rear of

Intellex unit.

COM 3, COM 4 These COM ports are assigned to either the external

USB modem or the port expanders. The external USB

modem must use COM 3 or COM4 to be used with

pcAnywhere.

COM 5 This COM port is used by the internal modem if it is

installed. If there is no internal modem, it is assigned

to the port expander.

COM 6 and higher Assigned to port expanders.

1 2 ... 205 206 207 208 209 210 211 212 213 214 215 ... 237 238

Brak uwag

Sensormatic Intellex Instrukcje Operacyjne Strona 210