Sensormatic VM 8 Instrukcja Operatora Pobierz pdf (Strona 63)

4-18 Operator's Manual

6. Press the number 1 on the keypad.

The following message appears on the LCD:

Record Pattern 1

Finish w <Next>

7. The Auto Pan is now being recorded. Any extraneous up or down

movement will be ignored when programming the Auto Pan.

If you pressed an invalid number (any number greater than 3), the TOUCH

TRACKER will beep and the system will not allow you to program the

Pattern. If this happens, simply press a valid number and continue with

this procedure.

8. Move the camera until you see end point for the Auto Pan you are

programming. Keep in mind this end point must be less than one full

revolution of the dome.

9. When you see the end point, press the Next button.

The following message appears on the LCD:

Cam 3

Pattern Saved

The TOUCH TRACKER automatically returns to the camera control mode.

In the List of Patterns (in Appendix A of this manual), make a record of

the Auto Pan that you just defined, including a brief description of the

Auto Pan.

To test the Auto Pan that was programmed, press 1, then Pattern. The

Auto Pan will run continuously until a camera command, such as tilt or

focus, is issued.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 111 112

Brak uwag

Sensormatic VM 8 Instrukcja Operatora Strona 63